Published: 01 October 2014
Analyst(s): Supply Chain Community Contributors
Like many other companies, GE is looking into integrating manufacturing at an earlier stage in the supply chain. One technology it sees as having a big impact is 3D printing, also referred to as additive manufacturing. For GE, 3D printing opens up a new paradigm about how it thinks about design.
©2021 Gartner, Inc. and/or its affiliates.
All rights reserved.
Gartner is a registered trademark of Gartner, Inc. and its affiliates.
This publication may not be reproduced or distributed in any form without Gartner’s prior written permission.
It consists of the opinions of Gartner’s research organization, which should not be construed as statements of fact.
While the information contained in this publication has been obtained from sources believed to be reliable, Gartner disclaims all warranties as to the accuracy, completeness or adequacy of such information.
Although Gartner research may address legal and financial issues, Gartner does not provide legal or investment advice and its research should not be construed or used as such.
Your access and use of this publication are governed by Gartner’s Usage Policy.
Gartner prides itself on its reputation for independence and objectivity.
Its research is produced independently by its research organization without input or influence from any third party.
For further information, see
Guiding Principles on Independence and Objectivity.